-
- News
- Books
Featured Books
- pcb007 Magazine
Latest Issues
Current IssueThe Growing Industry
In this issue of PCB007 Magazine, we talk with leading economic experts, advocacy specialists in Washington, D.C., and PCB company leadership to get a well-rounded picture of what’s happening in the industry today. Don’t miss it.
The Sustainability Issue
Sustainability is one of the most widely used terms in business today, especially for electronics and manufacturing but what does it mean to you? We explore the environmental, business, and economic impacts.
The Fabricator’s Guide to IPC APEX EXPO
This issue previews many of the important events taking place at this year's show and highlights some changes and opportunities. So, buckle up. We are counting down to IPC APEX EXPO 2024.
- Articles
- Columns
Search Console
- Links
- Events
||| MENU - pcb007 Magazine
Estimated reading time: 1 minute
Contact Columnist Form
Trouble in Your Tank: Case Study: Plating Nodules— Where Did These Come From?
Introduction
Sometimes the problems can really get pretty ugly. One would assume these uglies would be easy to correct. But most often, solving such a problem requires a much deeper dig into the process. In this column this principle will be illustrated with a real-life case study. In this real-life troubleshooting exercise, plating anomalies were detected on the PWBs plated in two different plating cells. This study points out that the root of the defects is rooted in two different causes. One is related to addition agent control, the other to solution filtration and anode maintenance. The study digs into plating roughness and multiple causes and corrective actions.
Severe Plating Roughness/Nodules
In previous columns, this author has presented many possibilities for copper plating nodules. However, what occurred with one PWB fabricator was on the extreme (Figure 1).
In Figure 2, a somewhat different type of nodule appeared on circuits at the same fabricator. Only this defect occurred on circuit boards plated in a different cell.
Basically this fabricator was seeing two different types of nodules/roughness. The nodules depicted in Figure 1 clearly show “normal” copper grain structure (fine-grained equiaxed). However, in Figure 2, the grain is quite large. In addition, the nodule/roughness shown in Figure 1 can be traced to what looks like debris that has been essentially plated up and around.
Editor's Note: This column originally appeared in the October 2016 issue of The PCB Magazine.
More Columns from Trouble in Your Tank
Trouble in Your Tank: Supporting IC Substrates and Advanced Packaging, Part 5Trouble in Your Tank: Electrodeposition of Copper, Part 6
Trouble in Your Tank: Electrolytic Copper Plating, Part 5
Trouble in Your Tank: Processes to Support IC Substrates and Advanced Packaging, Part 4
Trouble in Your Tank: Processes to Support IC Substrates and Advanced Packaging, Part 3
Trouble in Your Tank: Electrodeposition of Copper, Part 4—Addition Agents
Trouble in Your Tank: Lead-free and the Fabrication Challenge, Part 1
Trouble in Your Tank: Processes to Support IC Substrates and Advanced Packaging, Part 2